Hey everyone, here is yet another little how to on an hid install. I did not want to see any wires nor did I want to drill any holes. And I'd like to share how. All and all, I'd say I am very happy with the end result. Anyway, hope this helps someone:
1) Remove the windscreen
To do this, remove the front four black screws.
Then, remove mirrors by unbolting the two nuts on each side.
2) Now begin removing the front cowl assembly and headlight.
Remove these bolts on both sides, disconnect the harnesses, and remove front cowl.
3) Install the HID Bulbs in headlight
Grab the two lights from kit.
On the left is what the O.E. looks like and on the right is with the HID bulb in, and wires not yet ran.
*It is important to note what is going on here. I am removing the O.E. black harness and am replacing it with the new wires that are attached to the bulb. I am running them through the hole that is already provided.
This is what it looks like after.
4) Creating power harness for ballasts
I removed the blue connector from headlight harness, because I will not be using them anymore...
Use the power harness provided in the kit...
And splice using Yamaha's blue connector to the kits...
5) Mounting ballasts
This is somewhat self explanatory, but I mounted mine right above each of my turn signals inside the fairings.
6) Attach and bolt back up
Now it is as simple as bolting headlight back up into the cowl, bolting cowl back up the fairing stay, and connect harnesses.
Finish (except for the mirrors)
**Yes, that's Samuel L. Jackson on the tv...