Yamaha R6 Forum: YZF-R6 Forums banner

TPS adjustment

4K views 3 replies 3 participants last post by  brutalvette 
#1 ·
I have a 99 R6. I wanted to adjust my TPS, so I turned the bike on and set it to run. I unplugged the TPS and plugged it back in to enter the diagnostic mode. It was reading 10,000 rpm. I tried to adjust it and it seems like it only has three positions: 10,000, 5,500, and 0. Should it make a clean sweep and be able to hold any position? I tried to clean it out with contact cleaner and it made no difference.

Thanks for any help.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top