Yamaha R6 Forum: YZF-R6 Forums banner

dynojet QS: where to wire ground?

1K views 5 replies 5 participants last post by  Ebster1085 
#1 ·
I am trying to install my dynojet QS and I'm using a bauce racing flashed ECU.

Is there a best place on the bike to hook up the QS sensor's ground wire?
 
#4 ·
Is your QS hooked right up to the ECU? If so you want to wire the ground wire on the QS to the ground wire of the tip over sensor to help eliminate electrical noise. If the QS is acting up, buy a ferrite choke for it.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top