Yamaha R6 Forum: YZF-R6 Forums banner

1st Gen fork info needed

733 views 4 replies 4 participants last post by  Rij1 
#1 ·
I need to know what size seal driver I need and what seal driver I should get if possible.
 
#2 ·
Im 99% sure its a 43mm. It might be worth buying a cheap set of calipers to measure it.
The 2nd gen was 43mm.
I havent looked in a while but the ringer seal driver from motion pro may be the only driver they make now. Buy one of their bullets that protects the seal lips as you slide it on the tube. And a jar of seal grease. Race tech sells it. I think its $5.
 
#4 ·
It's a 43 according to Race Tech.

I use the Race Tech tools, but they are pricey (I do a lot of forks). Try Motion Pro.
 
#5 ·
Cool, thanks guys. I ordered the Tusk adjustable one since it'll work with my other bikes as well.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top