Ok peeps, need your help
I flashed a bike (super far away from me, mailed me ECU), 2007 R6, USA version (verified with picture of ignition cylinder).
Flashed with the latest version of the software (184.108.40.206 or something):
I used the built in map in the new software (they've done a lot of tweaking), then just loaded the MJS fuel map, did my throttle tweaks, that's it.
Customer got the ECU back, put it in bike, doesn't start. It cranks good, but doesn't fire. Getting code 50 (bad ECU) and 46 (bad fuel injection) flashing where the coolant temp normally is
The ONLY thing I did different with his bike, versus the other 65 I've flashed is that, in the new software, I calibrated his speedo for his custom sprockets (as can bee seen in the above image). I sure damn hope that's not the issue
Anyone seen anything like this?