i just bought a spy 5000m and i have all the sirens, proximity sensor and lights, and the ignition turns on when i press the remote start button, but i have three wires left that i cant figure out where they go, the manual says one goes to the cdi which i dont think i have, and the other two are supposed to connect to a wire i am supposed to cut in half and i cut about 4 wires and i cannot get it to work


anyone know how to install it ?

I would call the manufacture and ask them. They will be more accurate.

-Ant.

there is no manufacturer, as stupid as it sounds, the instruction manual has a half page for a diagram, and thats it.. no phone numbers to call or anything. i have most of it hooked up, i am trying to find out how to attach the anti-hijack wires (pink-grey wires), and the blue wire ( which i guess is the starter wire ) says it goes to the start line.?

attached is the diagram the alarm came with, its mostly small and confusing, even for a professional

http://i163.photobucket.com/albums/t311/EricSouza/diagram.jpg

http://www.scribd.com/doc/27462278/Spy-5000m-Installation-on-Suzuki-Gsxr-600


scroll down when the page uploads and there are more instrudtions that may help. Attach the anti-hijack wires are to cut the 12v to the ecu so the bike wont work. You need to find the 12v to the ecu when you turn the key. You cut that wire and the pink goes towards the ignition key and the gray goes towards the ecu 12v.

I am using that link but since he has a gsxr the wire colors are different, thanks though


the local alarm shop said theyd finish the install for 75 bucks

i am gonna try it again today then i might go there

I found this in various forums>>>

" just t-tap the
positive (+) starter wire on the alarm and use a relay to switch from
positive (+) to negitive (-) then use the neg output from the relay to
trigger your clutch wire this way your clutch and starter wire are
triggered at the same time "


"2005 raven,
12v: red or orance @ ignition harness (+)
starter: blue/white @ starter button (strong -)
ignition 1: brown @ ignition harness (+)
ignition 2: blue/white or blue/yellow @ ignition harness (-)
Brake: green i believe @ right handlebar harness (+)
kickstand switch: black (2 pin harness with 2 black wires, need to
test) @ kickstand (- with stand up)
neutral switch: white @ small 1 pin blue plug under gas tank on left
side (- when in neutral)
Tach: odd colored wire @ fuel injector. If you really want tach, the
wires are visible but will be difficult to get to
"