I installed a new set of front turn signals today. The left one went in without a problem. When I went to install the right side, I accidently crossed some of the wires and blew the signal fuse. I replaced the fuse and the left side works fine. I get running lights on the right side, but no turn signal. When I disconnect the front signal the rear right signal works.

Can anyone help me figure out what happened? The wiring should be correct, any other way the fuse blows or I get nothing at all.

Thanks...

try checking that bulb again. sounds like your bulb shorted or burnt out. try swapping out the front bulbs. if the problem is now on the other side, replace the bulb.

when you have the front right connected does the rear right signal blink rapidly???

when the front is connected i don't get any type of blinking on the right side. i get the rapid blinking when i disconnect the front.

what type of signals did you get? LED or Bulb type?

bulb type. Lockhart Phillips

http://www.lockhartphillipsusa.com/pages/product-sub3.asp?id=136