Yamaha R6 Forum: YZF-R6 Forums banner

Motodynamic nightmare

2K views 9 replies 5 participants last post by  motoman21 
#1 ·
I have tried to install a smoked Integrated tail light everything went smoothly until I reassembled the fairings. Then I realized the rear only flashed on 1 side non stop it wouldn't turn off and the other turn signal would not work. I switched the connector then the same problem in reverse. To make matter worse the 6 Phillip head plastic caps wont unbolt to remove the upper-tail fairing. I already broke 1. I am just disgusted with myself right now. I would appreciate any ideas
 
#2 ·
Do you have any pictures?

First, check the harness that came with the tail light. They should look like this. If not, correct it.
 
#4 ·
Could you please take some pictures, and post them, so we can help you out a little more?
 
#9 ·
just installed it on my 2012 a few weeks ago. pretty simple install, a true plug and play.. i did do some research on how to remove the old taillight before i actually bought it... you can find alot of good info on here and on youtube. some advise, if you are going to install a new tailight, buy a FE, if your going to change that as well... its easier to install both at the same time.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top