Yamaha R6 Forum: YZF-R6 Forums banner

my dino

2K views 13 replies 5 participants last post by  alex ninkovic 
#1 · (Edited)
this is photo of my measures- yamaha r6 2008 without ram air. I would like to know your opinion about this measures.
 

Attachments

See less See more
1
#3 ·
The dyno chart shows max 126hp and 49.9 lb ft torque.

It's hard to know if those numbers are good, because it doesn't say in what mode the dyno was done in (SAE, STD, the correction factor, etc.).

There is certainly a good improvement from the baseline run to the maximum run, but that is usually the case with successive dyno runs back to back.

It would be helpful to get the chart of the AFR (Air Fuel Ratio), without it you can't really tell how good your tune is.

-Jamie M.
 
#12 ·
Did you remove the stock muffler in the underbelly on the bike at all?

I've seen R6's run great on stock mapping with your setup. I've also seen em run a lot stronger as well after ECU flashing that includes a mild increase in fuel.

So if you have no power commander, all you got was the bike dyno'd and not tuned? I'm getting confused cause you said it was tuned at idle to a specific AFR?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top