Today I installed the used Krypton projectors/halos into my housings that I bought from the classifieds.
I put them in my oven for 12 minutes at 200 degrees.
Immediately removed the lenses with flathead screwdrivers.
Reflectors removed by the 3 screws on the backside.
Projectors fitted in the housings.
Lenses back in place.
I used my heat gun on low to soften the original sealant and applied pressure to push the lenses back in their place.
Backside of the unit.
All that's left is to install them on the bike. I'm not very good with the electrical part, so hopefully it doesn't give me too much trouble. If so I will contact a friend for assistance.