So check this out!!!!!!
I have a 07 r6s with 05 fairings... So i wnet to change my fairings with the new ones i bought.. so i also painted my tank.. welllllll... i took the air box off in the mean time waiting for the paint to dry... and shot carb cleaner into the throttle body ... to spruce it up.. it was idling ruff! thought it might help.. so after insatlling everything back fairings and all i go to ride and it is running on 3 cyclinders! so i exam and find which one is not running by puttung water on ehxaust pipes.. so i change all spark plugs and take fuel injectors off to exsm them.. all is well.. so i take the cyclinders injector that wasnt running and put into another cyclinder... to see if it is faulty... cauz that would cause the cyclinder it is in now not to run.. also i changed the park plugs ..so put it all back together... all 4 cyclinders are running good and strong.. BUT>>>>>> now mi idle is sitting at 3,500/3,600 rpms...wtf? i exam idle screw... i unscrew it to were it is not even touchn the throttle... still 3,600 rpms... i now suspect a vaccum leak... so i spray carb cleaner around and it idled higher bearly i mean just bearly around the throttle boddy boots that conect to the mootor.. so i take off the throttle body and inspect boots.. they r perfect.. re install throttle body and connect everyhting.. still 3,600... wtf i am stumped... PLEASE HELP ME
also i sprayed so carb cleaner around again after i put it back together.. AGAIN.. and in the front by the spark plugs there was a section that i sprayed by the 2nd plug (2nd plug from the left if u were sitting on the bike) and it idle bearly i mean just bearly again higher.. wtf could be up there by the plugs that might be causing a vaccum leak if at all a vaccum leak is the problem???? plzzzzzz help me...... plz