Fill/bleed brakes, install the Woodcraft shark fin, then button her back up I believe... I feel like there's more though... I'll def give it a once over, make sure all the bolts are tight and such, also swapping over to some Black DZUS fasteners in the process that showed up yesterday... Pretty sure that's it. Had to go pick up some tubing to bleed the brakes which is kind of why I called it quits. But with these new Stahlbus speed bleeders it should be a breeze! I've just got some school work to get done... So, more tomorrow!
Looking good!! looks like you're pretty much set for your race
Question though...y u no solder gear indicator wires? (pet peeve...i HAVE to solder all wires)
Funny you ask, I solder everything... But had zero interest in pulling the tank completely off so I'd have the room to do any soldering. So I just went with the taps and butt connectors. It did the job.. Needing to get so much done I didn't want to add even more time soldering and shrink wrapping everything. I've gotta get this thing wrapped up by tomorrow, so I took a bit of a short cut. It'll work for the time being! Siked to get out there man, thanks!
Kept The belly pan off since I've got To get it up in The bed of my buddy's big ass diesel Ford...
WTF is that on your lawn?
OES No Cut angle sliders,spools, bar ends
Modified 05 Headers
Modified Devil Rocket CF slip on
Block off plates-AggRacing
Bauce Flash-Bauce Racing
BMC Race Filter-Bauce Racing