Well I got my PCIII in, but no luck with the block off plates. Originally was going to order them from AGG, but when i went to put them in the cart it said he was out, so I went to STG and ordered some Graves ones only to find out a week later that STG didn't have any either. So I'm still waiting on plates, STG was suppose to have them shipped directly to me from Graves.
Re: Smog Block Off's (removal of air pump/smog block off install
I always appreciate when someone takes the time to do a write up. I built my bike from this forum and YouTube. Good to see members supporting the forum vendors too! Sub'd for when I order my AGG block offs.
BR is one to thank - I just make plates bc the original option of $39.95 shipped was stupid expensive. $20/set through today - and after I've lowered the price to only $22.95/shipped.
(excuse typos, as this was a mobile posting)
__________________
High-end, AFFORDABLE, parts and accessories for your bike!
ALWAYS free shipping to the USA, with 1-3 day delivery times.
Re: Smog Block Off's (removal of air pump/smog block off install
got a few pieces I need to get off you Anthony, PM comming shortly, but in regards to the install I've done this on my cbr where we use a gasket sealer i.e. rtv copper silicone from permatex in between the plate. is it not necessary for r6's?
__________________
If your not falling your not trying hard enough
got a few pieces I need to get off you Anthony, PM comming shortly, but in regards to the install I've done this on my cbr where we use a gasket sealer i.e. rtv copper silicone from permatex in between the plate. is it not necessary for r6's?
Ummmm I'm not aware of it but a couple thousand miles ago I removed my plates and I had shit that creeped inside. I may pull them again when my oil change comes up again and put some "rim" grease that you would use for an air filter.... If not ill use some high temp silicone sealant.
Linear Mode
