As shown in the diagram it holds the two intake tubes together and keeps them from rattling around in the nose cowl, not 100% needed but I would reinstall it
__________________ 2005 r6 raven, Motodynamic sequential signals, flush smoke front turns, 8k hid low, Devil racer carbon highmount ceramic coated black, Ohlins steering dampner, Motovation no cut frame sliders and bar end sliders, ASV levers, Vortex black rearsets, Corbin seat, K&n air filter, Factory Pro +4 ignition advancer, superflare vstacks, and slide stops, -1 520 conversion, Goodridge Shadow brake lines, Zero gravity windscreen, Stompgrip tank pads, NRC powdercoated racing covers, HINSON SLIPPER CLUTCH, Vented Brakes cooling system, Racetech internals front and rear with Michelin Power Pures holding it to the road
heh i still have one of those from my 03 r6, when i took apart the front end, i could never figure out how the hell it was supposed to fit back in there.
it was where there air intake hole meets the light housing.
i tried so many dift ways could never get it to fit right so i left it off.
Linear Mode
