All blinkers on my bike flash when I use my turn signals (both L & R). I've been told that it may mean there is a bad ground in the system... any ideas what the problem may be or how to fix it?
Did it just start out of the blue or did you install the flushmounts or the integrated taillight and then it started happening? Because the R6 has 3 wire front turn signals oem and flushmounts mostly only use 2 (ground and the power for the turn signal to flash, and at least on my integrated it used only the ground from the taillight itself not the ground for each signal for the whole housing then you just need the proper positive wires installed.
__________________ 2005 r6 raven, Motodynamic sequential signals, flush smoke front turns, 8k hid low, Devil racer carbon highmount ceramic coated black, Ohlins steering dampner, Motovation no cut frame sliders and bar end sliders, ASV levers, Vortex black rearsets, Corbin seat, K&n air filter, Factory Pro +4 ignition advancer, superflare vstacks, and slide stops, -1 520 conversion, Goodridge Shadow brake lines, Zero gravity windscreen, Stompgrip tank pads, NRC powdercoated racing covers, HINSON SLIPPER CLUTCH, Vented Brakes cooling system, Racetech internals front and rear with Michelin Power Pures holding it to the road
Did it just start out of the blue or did you install the flushmounts or the integrated taillight and then it started happening? Because the R6 has 3 wire front turn signals oem and flushmounts mostly only use 2 (ground and the power for the turn signal to flash, and at least on my integrated it used only the ground from the taillight itself not the ground for each signal for the whole housing then you just need the proper positive wires installed.
I bought the bike with the intergrated lights... its been doing it since I bought the bike regularly but every once in a while the signals will function properly.
Blinker problem
Linear Mode
