i know this will sound retarded but ..

[Chosen]

alright .. 25 is fine .. and ill check that up on facebook .. thanks

[deweese727]

No problem

[deweese727]

http://www.nwa-motorsports.com/m/index.htm

Here is their website too just in case.

[Chosen]

Thanks again

[deweese727]

Were you able to get what you need?

[Shush319]

I've made tag holders CHEAP! Like $6-7.

2 L brackets like this:


and 2 like this:


Bolt the 1st two to two of the holes so they hang down. Bolt the other two to those like a 7 and a backward 7 (you'll have to drill the holes where you need them. Trim with tin snips. I've done this for at least 10 people and several bikes I've fixed up to sell.

Then use a trim like this to make it look legit:


Looks like this when done (clean without blinkers(they are integrated in the tail light)):

[androcathr]

I'm sure you have a parts shop around your area. Check there first.

[Chosen]

deweese not yet .. and Holy SHit shush .. that is exactly something i was looking to do .. thanks so much

[Shush319]

Originally Posted by Chosen

deweese not yet .. and Holy SHit shush .. that is exactly something i was looking to do .. thanks so much

No problem.

I also used about 6" of some LED strip I had laying around for a tag light. You could also get the tag bolts that have lights in them. FL cops always looking for ANY reason to pull a crotch rocket over, tag light gives them 1 less....

PM me your address and I'll send you a light strip for yours if you want.

[StndIbnz]

Or do what I did.

When you take off the stock fender, there is a metal bracket inside the top that bolts to the bike. Take that out, it looks like a U. Bolt the bracket to the bike with the two bottom holes, then the other to on the "wings" (i'll call it that) you can flare out to the holes in the plate. Or drill new holes in the plate to match these.

It's free and easy.

Here is a quick sketch in Paint of what the bracket looks like.