Yamaha R6 Forum: YZF-R6 Forums banner

02 r6 custom jet size

4K views 14 replies 2 participants last post by  chaka433 
#1 ·
154's 1&4 main 40's slow . 148"s 2&3 35's slow stock pilot screws . 1 shim on needle valves. i am at sea level calif. i also have a cut off exhaust. runs super fast in mid range and full range, im just having a problem with idle ,carbs kind of chug. any suggestion, tps clean and snappy response on throttle. tell me your jet sizes.:YEA
 
#2 · (Edited)
#4 · (Edited)
They should all be the same. When was the last time they were sync'ed? Out of sync will make it lope too.
 
#7 ·
Spring or O ring missing?
 
#10 ·
No, screws are all the same. Pilots jets too. I never got mine super smooth until I went with next size up pilot jets.
 
#12 ·
I'm running #40 (#38 was stock), CA models #35 is stock.
 
#14 ·
:beerchug
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top