i just bought a bottle...first time doing this. Do you just fill up the tank then put the whole bottle in there? What about when its summer again do i just ride the bike normal? sorry for the dumb question.
Follow instructions on the bottle to how much you should add. First fill up the tank with gas, add the stabilizer, go for a 10-15 min ride or just let it idol for that long, shut off the bike and fill up the remainder of the tank with gas and your good!! It doesn't have to be in exact order except the last part!
Theres these things on the bottle, you combine letters to make words, and combine words to make sentences. Top to bottom, left to right, should be called 'EENSTRUKTONS'.
running the bike gets fuel stabilizer into the lines and injectors. Its important to prevent fuel degredation in these places. run the bike or take it for a ride after adding... it doesnt take very long at all to get the stabilizer into these places. its on the order of seconds since the fuel pump is always pumping fuel. but just run it for a couple minutes to make sure. and mix the stabilizer in the correct proportion.
well it didnt say how much on the bottle to pour in. It just says its good enough for a 30 gallon tank. is it bad if i poured the whole bottle? it was small....aww shyt...
kinda remind me of the gixxer kid with the nos "additive"
if it says the bottle treats up to 30 gallons, dont pour it all into 5 gallons. thats 6 times the concentration. pour in like a fifth of the bottle.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Yamaha R6 Forum: YZF-R6 Forums
3.1M posts
112.2K members
Since 2003
A forum community dedicated to Yamaha R6 motorcycle owners and enthusiasts. Come join the discussion about performance, modifications, troubleshooting, maintenance, and more!