In the Motodynamics Integrated Tail Light instruction sheet, there is a statement that states if running LED blinkers, such as my Hotbodies Flush Mounts, there must be ab inline resistor between + and - wires, reverting the LED's load back to OEM rate of flash to avoid tail light and blinker lights problems.
Does anyone know if the Custom LED Electronic Motorcycle Blinker Flasher Relay fixes this supposed conflict between LED Hotbodies Flush Mounts and the Motodynamics Integrated Tail Light?
I would rather not have to run the resistor between the wires on the flush mounts.
Thanks for saving me the hassle and time!
:YEA
Does anyone know if the Custom LED Electronic Motorcycle Blinker Flasher Relay fixes this supposed conflict between LED Hotbodies Flush Mounts and the Motodynamics Integrated Tail Light?
I would rather not have to run the resistor between the wires on the flush mounts.
Thanks for saving me the hassle and time!
:YEA