So i just got a lockhart phillips tinted windscreen and installed it... I had already bought their flushmount turn signals and they worked out great so I was hoping the windscreen would be just as good but its not
At the bottom of the windscreen just above the light in the nose, it looks like they just took a dremel and unevenly drilled off the remaining plastic. It leaves a bit of a gap between the windscreen and the light
It would look great if they had molded the plastic over at the bottom or made it a smooth surface. Also some of the holes didn't line up as well or sit as far underneath the mirrors as the factory windscreen. Anyhow, i wouldn't recommend this product. It was cheaper than most windscreens and it shows in the product quality. I might just paint my factory windscreen or put some windown tint on it and put it back on my bike instead.
lockhart phillips windscreen
Linear Mode
