Search Results for ‘clutch’

Hello everyone. I got my bike running and when I try to take off from a stop, in any gear, with no throttle, I slowly let the clutch out and the bike slowly dies. As soon as I pull the clutch back in, the RPMs go back to normal. I saw on beginner rider YouTube videos, people in parking lots...

Hi! I apologize in advance for the short novel. I have a 2004 R6 and my clutch started failing in May and I replaced it with an EBC kit (new steel plates, Kevlar friction plates, and springs). I put everything back together and it seemed to work (the clutch lever felt very firm, I didn't test...

Hi guys, it's been an eventful night... I recently picked up an immaculate 2008 R6 and been loving it ever since. Today I decided to put her up on a rear paddock stand and clean and lube the chain - done and dusted, all good. I then took it for a quick spin down the road and was immediately met...

I just got this 2012 r6 shifts great through all the gears except when the bike is running I can’t get it into neutral. The bike has no problem going into neutral after I hit the kill switch easy. I’ve tried moving the bike a little forward and back doesn’t work I tried letting out on the clutch...

I need the clutch kit for my R6 2017.Yamaha here, gave me the part number BN6-W001G-00-00 and that is backordered until end of May. Online I see another part number 2C0-W001G-00-00 but Yamaha Canada said that must be US specific, for Canada it is BN6. Is this true? It's hard to believe US and...

Hey all. I am looking to buy a 2005 R6, 23k miles. Guy said that some of the clutch plates broke inside so I would be picking it up pretty cheap. I would consider myself fairly mechanically inclined, so I thought this would be a good project to pick up. He mentioned that afterwards, the engine...

So I left my Yamaha R6 2011 in storage for 2 years in my garage located in Michigan. I used non-synthetic oil and rode it for 200-300 miles before storing it. The first thing I did before riding it was conduct an oil change using synthetic 20W-50 Valvoline oil and a new K&N filter. When riding...

My bike turned off (haven’t tried it on but I assume it is the same) in neutral rolls around like normal, like it should, clutch lever pulled or not. Then when I put it in gear, and keep the clutch lever pulled there is a lot of resistance. I have tried screwing in the adjuster by the lever all...

I was tightening my clutch screws and one just snapped. Im trying to find a part number or something for the thing the clutch screw goes into. Do I have to buy a whole new inner basket or could I just order this one little part somewhere?

So I was torquing the clutch spring bolts down on my 2007r6s and one snapped. I don’t have a clue as to why. It was the correct torque spec(70.8 in lb. I read it may be because the bolts are old/stretched. Do u recommend replacing all bolts. and tightening again to the torque spec? Or should I...

I recently replaced my clutch as I thought it went out because I lost power to my back tire on a Sunday drive last weekend. Apparently, my front sprocket jumped off the track which I didn not realize until after I switched and upgraded my clutch plates. For some reason, after installing the...

Hello guys, I have a (for me) strange problem with my 2017 R6 and would like some advice. My clutch was always engaging a bit and no matter what and which adjuster i adjusted it would still be the same. I figured that the steel plates could be warped from a burnout that i didn't do myself. So i...