Yamaha R6 Forum: YZF-R6 Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Garage / Mechanical Help
    So first off kickstand bypass is done. Had natural safety switch bypassed with neutral light on but still wouldn't start with clutch in unless the bike was actually in neutral. Also put jumperwire into both wires that connect to clutch safety switch. Still would only start when bike was in...
  2. Garage / Mechanical Help
    I have replaced the engine, the wiring harness, the battery, the starter relay the ecu and ohmed out my cps. I even changed the sensor after It ohmed good. I blew the bike up and changed the engine and ever sense I have had gremlins. My current gremlin is the nuteral switch only works when...
  3. Exhaust and fuel delivery
    Bike ran prior Yesterday i was watching vids on what my small little tick could be in my 02 r6 and went out and tried adjusting my tensioner , went to start bike and it did not start , dug into the timing chain and centered every mark and still not starting . Keep in mind the bike ran prior to...
  4. Garage / Mechanical Help
    My 2006 R6 has an idle issue and I don't know what the problem would be. It starts up fine but when it reaches 104 F it dies then has a hard time starting again and when it does start I have to keep the throttle open a little so it doesn't stall. and on hot days when its running at 185 F it...
  5. Garage / Mechanical Help
    So I bought my first bike about a week ago 2000 yzf-600r. It ran perfect for the first couple days but now when I’m in first gear and then shift into second gear the bike like just jerks back and forth like it’s getting stuck or something. If I accelerate slow I can get to about 7,000 rpm before...
1-5 of 5 Results
Top