Search Results for ‘power commander’

Full Dynojet setup of a 2011 R6. Everything works perfectly, pulled from a running bike. Power Commander V, Autotune Module With 02 Sensor, Secondary Fuel Module Fits 08-16R6. I'm located in Denver. Asking $450 obo, can ship no problem...probably ~$10 across the country. Cover plate is...

Hey all, I just bought a power commander 6 for my 04 r6 to make it run a little bit better and get better performance. There's one issue I am trying to figure out. On DYNOJET, the tune for an 04 r6 is just a stock basic tune and there's only that tune for my bike, but they have tunes for the...

Ok.. here we go I’ve got a 2005 R6, K&N filter, block off plates, 9” delkevic exhaust with mid pipe. When I bought the bike well over a year ago it had 3 OEM ignition coils and one DENSO coil (assuming it came off a 03-04) I recently purchased a used PC3USB to get the air fuel ratio correct...

You should be able to just reconnect those wires to the switch, without any problems. I would split that brown connector to get some extra slack. And as for the power commander, (I'm sure that I will be corrected if I am wrong) but I believe that the pcv is a piggy back system. So with Not...

I’ve made some mods on my bike 2009 r6 Full black widow exhaust Block off plates Pcv with autotune EXUP delete 02 eliminator I’ve tried different base maps and keep getting flat spots around 4-5k rpm Also sometimes around 8k I’ve also removed the pcv and still have the flat spot around 4-5k I...

Selling Power commander 22-031 that I had bought and never got around to install on bike. Sold the bike recently so have no need for it. Asking $150 + shipping. Located in Tucson AZ if you want to do local pickup.

I was wondering what the correct connection to the battery for the power commander was, currently it is connected to the negative of the battery. Also, I have a strange cable with the only label being "10A fuse" that is only connected to the plus and negative to the battery and nothing else. I...