Yamaha R6 Forum: YZF-R6 Forums banner
21 - 29 of 29 Posts

· Registered
Joined
·
3 Posts
I don't have spark on 1 & 4, the pickup coil ohms within spec and the coils are all good ohmed within spec all my primary's were .4 and my secondary's I had two 9.8s and 8.7 and 8.6 checked all my connections involved with ignition and no burnt or corroded wires
 

· Registered
Everything you need to know is in the Service Manual !
Joined
·
179 Posts
sorry guys i took so long to reply back, im in the military and i had a pretty long training schedule ... but i did check out the bike .... wires are gewd ... fuses were replaced wit new ones .... coils are gewd ... new spark plugs installed ... only thing left is the cdi .... checked every wire coupler that concerns the ignition and they all read right ... so what's next?? im stumped about this .... any help or suggestions is appreciated ....
Check your kickstand safety switch, tip over sensor. Both will kill spark if engaged
 
21 - 29 of 29 Posts
Top