Yamaha R6 Forum: YZF-R6 Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter · #1 ·
When taking my carbs out to clean, I broke the plastic nipple on the right side of the carbs that fits into the "balancing" hose which runs to the air box. I bought a new plastic nipple and am about to take off the carbs again to replace. From the shop diagram it looks to me like I can just pull the old one out and stick the new one in without dissassembling the carbs (mabye loosen the connecting bolt and braket.. not really sure.) Does anyone know if this is right?
 

·
Registered
Joined
·
15 Posts
Discussion Starter · #3 ·
Really quick. I had to loosen the connecting bolt and bracket then I just jammed it in and tightened the bolt. The bracket pushed it the rest of the way in. I didn't even have to pull the carbs all the way out. I left the cooling hoses connected.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top