Yamaha R6 Forum: YZF-R6 Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,334 Posts
Well you're doing the right thing by checking your connections and wiring. It could be a short or an disconnected wire somewhere.

Maybe you'll get lucky and check diagnosis system check and find a crank posistion sensor that is bad or something.

I highly doubt it is any of your safety switches, cause most of them won't even allow the engine to turn over.

But, get in, check the system for any failure codes, if ya find nothing, just keep checkin all the wiring.

Lemme know if ya have any luck.


If ya don't have a service manual, you'll have to download a version to get directions on how to check for those codes etc... Their is a download version of it posted on here somewhere, i think in the sticky section.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top