Yamaha R6 Forum: YZF-R6 Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hey fellas I'm new to the board. I have a r6 in the shop that I straightened out which was a mess, the previous shop left the intake boot bolts loose and one went down the port. The guy got lucky because it was to big to fit down the throat to the cylinder. The bike came in running on 2 cylinders. So I did a comp test all good, new plugs and tightened it all back up. The thing is it runs fine and on all four but it has an error code of 1 and 2. It runs good but flashes that on the dash. I'm an engine expert and have 30 yrs ex on bikes but not much on these code issues on various bikes where sometimes it good to ask for advice. I can tell you everything about a Busa and others but here I'm stuck. Is there a way to clear it? The guy said it did have those codes before I received it. Is there a way to find out what those codes are? I googled it but I'm coming up with coil 1 and 2 but the bike runs fine. Thanks for any advice.
 
1 - 1 of 1 Posts
Top