Yamaha R6 Forum: YZF-R6 Forums banner
1 - 6 of 6 Posts

· Registered
Joined
·
1,070 Posts
Discussion Starter · #1 ·
$175 obo + shipping

Located in MD

My Dainese jacket for sale. Bought it off the forum in September, and wore it about 5 times. Maybe even less. It is a great quality jacket, no rips or tears. Just looks a couple years old and well worn. No cracks in the leather. It is a little short for me ( I am 6'5" ), so I bought another Dainese jacket. Never hit the pavement. It also has a full circumference zipper.





The reddish strip at the bottom is the black reflective material built into the jacket.

PM me with questions.

-Will
 

· Registered
Joined
·
1,070 Posts
Discussion Starter · #2 ·
ttt
 

· Registered
Joined
·
1,070 Posts
Discussion Starter · #4 ·
does the zipper go left to right or right to left. also approximately whats your measurements and weight, and how did it fit besides being short?
thanks
For the vertical zipper it is on the left side. On the waist attachment zipper, it doesn't have the zipper piece on it, i assumed dainese pants would have it ( I dont have leather pants, I just wear my one piece instead). The zipper attachment point is on the left side.

I am 6'5" about 205-210lbs. My suits are a 42/44 long depending on who makes it. Let me know if this helps.

-Will
 

· I sold my R6
Joined
·
229 Posts
For the vertical zipper it is on the left side. On the waist attachment zipper, it doesn't have the zipper piece on it, i assumed dainese pants would have it ( I dont have leather pants, I just wear my one piece instead). The zipper attachment point is on the left side.

I am 6'5" about 205-210lbs. My suits are a 42/44 long depending on who makes it. Let me know if this helps.

-Will

wont really work for me then, i was hoping it would zip to my pants. good luck with the sale though.
 

· Registered
Joined
·
1,070 Posts
Discussion Starter · #6 ·
cool thanks!
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top