Yamaha R6 Forum: YZF-R6 Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
I have a 2001 r6, and Im thinking about doing a 2mm bore on the cylinders to bring it up to 637cc with a compression ratio of 13:1. I was wondering if anyone knows if i can run 91 pump gas with this compression ratio, also i was wondering what the life of the motor would be if i bored it out, any information on cam lobe settings and carb setting suggestions would be helpful.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top