Yamaha R6 Forum: YZF-R6 Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1
I installed flush mount signals in the front after wiring the new signals in they worked as they should. I started the bike and the headlight and taillights were not working. After i replaced the fuse the headlight and tail light came on but now the new front signals will not work. If i take the headlight fuse back out the signals then start working again. Any help would be great!!!!
 
1 - 2 of 2 Posts
Top