2006 R6 crank no start after crash

223 Views 2 Replies 2 Participants Last post by Intuit, 15 d ago

timmytimtim

My brother went off the road bout a month ago I have since stripped the bike down and right now no headlights are on the cluster is damaged(new one on the way). Anyway we plugged the cluster in and screens are messed up so can’t see anything but it does show the engine light blinking while cranking all wires i think are good I went over them and did a new stator cover. Im thinking maybe lean angle sensor. Any other ideas or could the damaged cluster cause it not to start? Also won’t crank in 1st with clutch pulled in only cranks in neutral

Tire Wheel Automotive tire Motor vehicle Automotive lighting

See less See more

Save

1 - 3 of 3 Posts

timmytimtim

Discussion Starter · #2 · 18 d ago

timmmytimtim said:
My brother went off the road bout a month ago I have since stripped the bike down and right now no headlights are on the cluster is damaged(new one on the way). Anyway we plugged the cluster in and screens are messed up so can’t see anything but it does show the engine light blinking while cranking all wires i think are good I went over them and did a new stator cover. Im thinking maybe lean angle sensor. Any other ideas or could the damaged cluster cause it not to start? Also won’t crank in 1st with clutch
pulled in only cranks in neutral View attachment 380794

Solved:
Cluster came in ended up being code 19, found a damaged wire on the ignition switch under the wire wrap stuff, would then start but die in gear quite a bit of researching and trying this and that led me to the starting cut off relay under the gas tank swapped it out from a running r6 and went right into gear! Rebuild looking promising.

Save

Reactions: 1

Intuit

· #3 · 15 d ago

Good work Tim. Brother doing good?

I know you aint' letting him anywhere near another super-sport after that...

That had to be scary.

Save

1 - 3 of 3 Posts

Top Contributors this Month