Yamaha R6 Forum: YZF-R6 Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
93 Posts
Discussion Starter · #1 ·
Anyone that has a 2007+ R6R i need a quick measurement done with a caliper.

See picture.

Can someone with the stock steering head bearings measure this distance for me, from the frame to the underside of the top triple clamp? in MM

I have put in tapered bearings and want to know if this distance is the same or not.

Please and thanks!!

 

·
iRun
Joined
·
33,317 Posts
Would if I could, but all my stuff is down the road and across the country. Good luck! :cheers:
 

·
Registered
Joined
·
93 Posts
Discussion Starter · #7 ·
with the all balls kit the space is about 11mm
i wanted to know if it was the same as stock or a little higher/lower since that affects where you should have the forks in the clamps but looks to be about the same.

Thanks bronco..
 
1 - 8 of 8 Posts
Top