Yamaha R6 Forum: YZF-R6 Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
What’s going on everyone, I’m hoping I can get some advice on my testing that I’ve done to see if I’m missing something. My bike has 2,400 miles on it. This spring I brought it out of storage and had an issue where it was running really rough at idle, when throttling up it ran much better. A few days later now it just cranks, will fire for a brief second then stall. After all my inspections and testing I’ve come down to this weird issue. When the bike is in Diag mode, I can pulse each injector separately with a noid light hooked up and see the computer pulse each injector individually. But when I take the bike out of Diag mode, and hook the noid light back up, I’m only getting injectors number 2/4 firing. It will not pulse on cylinders 1/3. But again, during the Diag test all 4 show a pulse. So wiring is good, injectors were tested and work on bench with good flow. Is this a bad ECU???
 
1 - 1 of 1 Posts
Top