Yamaha R6 Forum: YZF-R6 Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
353 Posts
Discussion Starter · #1 ·
ok, well my throttle has some slack in it again, but i don't feel like taking it to the dealership just to get the throttle tighened back up

so, how do you do it?

i'm sure its simple, its just that i have no idea how to do it.

i'm guessing that its just stretched out a lil again.......so how do i tighen that beotch up?

thanks guys
 

·
Registered
Joined
·
34 Posts
look underneath the throttle handlebar. two cables go from there down to the engine. loosen the locknut on the cable closer to the front of the bike. turn the adjusting nut in the direction that decreases slack (clockwise if viewed from right side) until you are satisfied. then tighten the locknut when you are happy. start the bike and make sure that the idle speed doesn't change when you move the handlebars from left to right.
 
1 - 4 of 4 Posts
Top