Yamaha R6 Forum: YZF-R6 Forums banner
1 - 10 of 10 Posts

·
Registered
Joined
·
1,500 Posts
Discussion Starter · #1 ·
anybody have a good write up including pics on how to install this bodywork? i searched and can't find anything on it. thanks guys.
 

·
Registered
Joined
·
5,244 Posts
Start at the upper. Work your way down.
The upper should attach to the fairing stay & the frame.
When you put the lower on you may need a second set of hands eyes or a piece of wood underneath the pan & a mirror on the opposite side.
Figure out where you want your dzus fasteners and pencil the areas to drill.
Same with the stock frame mounts.(if youre using them)

Tail section is pretty easy. Shouldnt take more than an hour to fit them.
 

·
m3lover2
Joined
·
10,527 Posts
If you still don't get it done Till the 2nd week of march. Hit me up.. I'll help. I just got too much going on till then
 

·
Premium Member
Joined
·
3,027 Posts
+1 on the video!! plus the Armour Bodies fits real good so the holes lines up perfectly without any modification.
 

·
Dangerously Irish
Joined
·
9,550 Posts

·
Dangerously Irish
Joined
·
9,550 Posts
Everything on mine fit spot on, except for the fender. All my holes are where their little dimples were.

Sent from Motorcycle.com Free App
It's hit or miss, on NESBA you can send photos of your part to AB on their thread. If it doesn't line up they'll replace it. I was too lazy for all that jazz.
 
1 - 10 of 10 Posts
Top