Yamaha R6 Forum: YZF-R6 Forums banner

1 - 3 of 3 Posts

·
TJ
Joined
·
19 Posts
Discussion Starter · #1 ·
Ok so i got flush mounts off ebay and they have a red wire and a white wire, which i assumed were hot and ground. I have an 04 r6 and found out the three wires from the harness on the bike were as follows: blue is running lights, brown as blinkers, and black as ground. So i wired up the left blinker and taped off the blue wire and it works fine. Then i wired up the right one and now the right rear blinker, the front right one, and the blinker indicator don't work. I unwired the right one and the rear right and indicator work again. I don't understand how this is. I have checked the signal fuse and it is fine. Any suggestions?
 

·
MACGYVER 05 R6 NJ
Joined
·
4,033 Posts
Rewire the old blinker back. If it works then you may have a bad blinker or you need a flasher relay. Test the blinker buy wireing it up to a 12v battery.
 

·
TJ
Joined
·
19 Posts
Discussion Starter · #3 ·
problem is i don't have the old blinker, it got trashed when i laid it over a while back..but i'll try the battery idea
 
1 - 3 of 3 Posts
Top