Yamaha R6 Forum: YZF-R6 Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I am planning on synching my cards this weekend. I bought a motion pro gauge that should be here thursday. I was going to buy some fuel line and extend it to the tank and sit it on a stand. I bought an 11" flat screwdriver. That should be all the tools I need correct? Is the fuel line 3/8? I did a search but didnt find anything. I also have the manual. Is there any tips to simply any part of the process? And finally is it absolutely neccesary to remove the air filter box( I had a time getting it back in last time i had it off,not really difficult just time consuming)?
 

·
Registered
Joined
·
106 Posts
The mercury is a BEOTCH to put in. You'll see.
You shouldn't have to mess with any fuel lines. You can do the adjustments with the tank tilted up.
You don't HAVE to take the entire air box off, just take the filter out, and leave the top off, the manual will tell you what sensors to disconnect.
 
1 - 2 of 2 Posts
Top