Yamaha R6 Forum: YZF-R6 Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
44 Posts
Discussion Starter #1
Just replaced my clutch now I’m having an issue. The cover is on everything is good with the pull rod but I cannot get my cable to be taught. The lever is always flimsy and will not pull the cable I’ve adjusted both sides of the bike but I cannot get it to tighten up....any suggestions?
 

·
Registered
Joined
·
44 Posts
Discussion Starter #3
Not sure. It’s not frayed I think it’s correct length...it was when I removed clutch pack the stack even lost a mm this go around. Pull arm is in right position so I’m kinda at a loss
 
1 - 3 of 3 Posts
Top