Yamaha R6 Forum: YZF-R6 Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
585 Posts
Discussion Starter · #1 ·
So I just finished putting on my clutch, sealed the cover and put on the lever and adjusted the cables, now I can't figure out how to get that stupid E-clip on the bottom of the lever.

It has two little holes on the ends.

Any suggestions?

Also, when screwing in the bolts that hold in the brings, I was able to keep tightening them but I stopped because my torque wrench said about 5 ftlbs. This normal? I did switch to barnett springs.

Thanks
 
1 - 1 of 1 Posts
Top