Yamaha R6 Forum: YZF-R6 Forums banner
1 - 3 of 3 Posts

· Registered
122 Posts
Discussion Starter · #1 ·
So was looking into cutting the stock can on my 04, making it shorter, to me from what I have seen it sounds a bit better. I have searched the forum and didnt really find anything about cutting the stocker down. Anyone done it have some tips? Is it basically just cutting the can down, drilling out the rivets and taking the end cap off, putting the end cap back on, redrilling then riveting the end cap back into place? Do the inside pipes of the cans match up or are they off? Thanks for any help I can get.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.