Yamaha R6 Forum: YZF-R6 Forums banner

Dayton Ohio Benefit ride !

1459 Views 13 Replies 4 Participants Last post by  PEnGUiN188
Hey . i know some of you are in dayton ohio... or cincy

Hit me up . there's a benefit ride starting out in trenton ohio on may 10th . gonna be a lotta bikes. If you want more details e mail me or PM me.

E-mail : [email protected]

In short .
MAY 10th . Trenton OH
1 - 14 of 14 Posts
A little girl i know's dad died and they are building a trust fund for her.. you should come out man ... only 10 bux
might have to. Send me some more info. Any idea what the weather's looking like yet?
Sat will be

High: 68 °F RealFeel®: 70 °F
Times of clouds and sun

I was thinking about it, but I have work at 2pm, what time does it all start?
If you want you can meet me in eaton at the wal mart.. i'll be meeting about 8-10 bikes there and riding down.

Any more info you guys need just hit me up.
Update ! ! All Info:

Registration : 10:00 Am - 12:00 Pm
At Yardbirds In Trenton, Ohio (rt.73 And Wayne-madison Rd.)
First Bike Leaves At 12:30 Pm
$10.00 A Rider And $5.00 A Passenger

Stops Are As Follows. :
Charles Throttle Shop, The Farm, The Golden Key, And Ending At Mutts Brewery Lounge.

Live Music (flight 420) , Food, Door Prizes, Auction, Etc.

All Proceeds Will Go Into A Trust Fund For Mackenzee Weber Set Up At Fifth Third Bank.

Need Directions Or Anything Contact Me ... Hope To See You There !
See less See more
can't make it mang. gots to work til noon tomorrow
Mitch, I can send you a few bucks to add to the pot if you want.
Appreciate it but i dont wanna do that haha

There's gonna be a lot of bikes anyway to raise a decent amount for this little girl...

Thanks james
Weather held out for it, but I was so tired from the night before and meeting that morning at 7am that I didnt go.
7 am???? it was from 10a - 1230p
7 am???? it was from 10a - 1230p
I had a work meeting at 7am. than had to come back at 3.
1 - 14 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.