Yamaha R6 Forum: YZF-R6 Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
47 Posts
Discussion Starter · #1 ·
so i took it all apart to get the levers powder coated and little did i know there is a spring and ball underneath it. the ball went flying and is know wheres to be found. my dealer says i would have to get a whole new clutch lever. is there any place a i could find this ball or even if i could how do you get it back together. thanks
 

·
Registered
Joined
·
4,950 Posts
sounds like a good time for some CRG's or Pazzo's


EDIT: oh, you were powdercoating. nevermind my post. Maybe someone who has put CRGs or Pazzo's on will have the stock levers and hardware for you?
 

·
Registered
Joined
·
47 Posts
Discussion Starter · #4 ·
well i actually just put it back together without the ball right now. all it does is act as a detent for the dial, i actually stretched the spring a little so it is still doing the same thing just not as smooth for now.
 
1 - 4 of 4 Posts
Top