Yamaha R6 Forum: YZF-R6 Forums banner

1 - 11 of 11 Posts

·
Whatever happens, happens
Joined
·
114 Posts
Discussion Starter · #1 ·
So I installed the TST integrated tail light and flush mount blinkers yesterday. I didn't install the load resistors because I didn't want to cut any wires, but do I actually need them?

After the install the blink speed looked fine to me. So is there any negative affects if I leave them out?

I have a 2014 if that matters.
 

·
Registered
Joined
·
118 Posts
nup, only thing they will do is burn out quicker. Though relay is literally a 2 minute install (unplug, plug in) under the seat
 

·
Whatever happens, happens
Joined
·
114 Posts
Discussion Starter · #3 ·
But that's if it blinks too fast correct? Mine blink the same speed as stock.
 

·
Hello
Joined
·
527 Posts
you will if the laws in your area state that turn signals must flash at a particular rate. And as stated, remove the seat and it switches out easily enough. Its worth it.
 

·
R6 noob
Joined
·
49 Posts
Who makes and sells this resistor/relay? I need it for 2004 R6 with hyper blinking syndrome :( And just plug and play correct? I got LEDs front and back if that makes any difference.
 

·
R6 noob
Joined
·
49 Posts
Ended up ordering the TST Industries Gen 2 LED flasher relay. Only $18.50 +shipping and it covers all 4 of my signals plus it has an adjustable flash rate.
 
1 - 11 of 11 Posts
Top