Yamaha R6 Forum: YZF-R6 Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
50 Posts
Discussion Starter #1
I installed a full system Yoshi RS3 on my 03 R6 with stock filters and I just hooked up my PCIII to my R6. I can't find a damn map for the yoshi full system, only the slip on. Does anyone have a clue where I can find one? Cuzz da Yoshi site and the Powercommander site don't have em. Thanks
PS: I have a U.S. Specs bike
 

·
Registered
Joined
·
4,159 Posts
on the Powercommander website, there should be a list of approved shops for your area where you can get a custom map made up for it (dyno run and exhaust gas analyzer). There is one for an '03 with an Arata full system. http://www.powercommander.com/usermap407.shtml map name M407-DK122, at the very bottom. Other than that, I can't seem to find one . this is the website that submitted the map and they have http://www.kyleusa.com/ .
 

·
flyin' hawaiian
Joined
·
2,815 Posts
okay fellow forum members. i have a '03 R6, planning to install power commander when i recieve my exhaust. anyone here got a map for a '03 with Devil Bikes SB2 high mount? if anyone here has it could they post it here or post a link. i dont want to order this exhaust with out this map.
 

·
Registered
Joined
·
7 Posts
stoneloco808 said:
okay fellow forum members. i have a '03 R6, planning to install power commander when i recieve my exhaust. anyone here got a map for a '03 with Devil Bikes SB2 high mount? if anyone here has it could they post it here or post a link. i dont want to order this exhaust with out this map.
I had a devil shotgun on my setup before. From what i hear, it's a good idea to run the micron slip on map for the devil SB2. I can try to send you the map I had for my devil shotgun as well. I dynoed it and it was pretty smooth but still a tad rich at about 12.8:1 a/f
 
1 - 4 of 4 Posts
Top