Yamaha R6 Forum: YZF-R6 Forums banner
1 - 1 of 1 Posts

·
I said biiiiiiiitch.....
Joined
·
525 Posts
Where did you wire the yellow wire for the signals in?

It sounds like the fan and dash backlight are also on that circuit. When you enable/disable the alarm, the unit flows electricity from your battery through the circuit the yellow wire is attached too. That's what makes the signals blink, but it will also power anything else on that circuit.

I've never wired one into my R6, but I put a similar alarm in my GS500. It did the same, and would light up my dash turn signal light.

EDIT: I just saw you used the green wires in the tail section. I'm trying to find a wiring diagram now.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top