Yamaha R6 Forum: YZF-R6 Forums banner

1 - 10 of 10 Posts

·
Yeah i can get it up.
Joined
·
148 Posts
Discussion Starter #1
I just did my 06 r6 and it was easy to reverse the stick. im looking at my girls 05 r6 and ive noticed the stick goes through a hole in the frame.. and way to by pass this ? bend the stick ? my girl is used to gp shift on my bike.. so id figure i do hers the same . any advice would be greatly appreciated :)
 

·
fok mi! fok u!
Joined
·
260 Posts
I had graves rearsets on my '05 R6. that solved the gp shifting :) my '08 also has Graves and my '06 has vortex.

I would look on ebay for rearsets!
 

·
Yeah i can get it up.
Joined
·
148 Posts
Discussion Starter #3
so aftermarket rear sets can be fully adjusted to gp right ? wouldnt it still run the the frame on the 05 ? if thats the case, ill save the trouble and just purchase a set off ebay
 

·
Registered
Joined
·
556 Posts


I just bent it
 

·
Registered
Joined
·
556 Posts
Table vise and a big ass box end wrench.. didnt wanna heat it up.
 

·
Shiney up Rubber down
Joined
·
4,936 Posts
"woodcraft gp shift rod" for 03-08 R6 is what you're looking for. I think I bought mine on kneedraggers dot com for like 25 bucks or something like that.
That way you don't have to bend your stocker, and worry about breakin it.

Enjoy
 

·
Work Hard, Play Hard
Joined
·
240 Posts
I just got my woodcraft in the other day and installed it! Was simple install and love the GP shift. It's nice to still have my stock incase I ever go back or want to sell it down the road. Woodcraft had great customer service by the way. Just no directions with the part.
 

·
Registered
Joined
·
1,227 Posts
"woodcraft gp shift rod" for 03-08 R6 is what you're looking for. I think I bought mine on kneedraggers dot com for like 25 bucks or something like that.
That way you don't have to bend your stocker, and worry about breakin it.

Enjoy
yes and its a much cleaner look as well
 
1 - 10 of 10 Posts
Top