Yamaha R6 Forum: YZF-R6 Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
71 Posts
Discussion Starter #1 (Edited)
I am looking for a way to use just the ignition wires to make a switch for starting my bike 2009 Yamaha R1/R6 (same ignition wiring). Currently I'm using the hot wire from the ignition and crossing it to the kill switch and it works, but
I do not want to use kill switch to power and stop the bike. I have made many of these for people on the R1 forum using a few different options to add a little security. here is one of the ways I have made them:

http://flic.kr/p/abgHBr

Here is a link to what is setup on my bike now

http://www.r1-forum.com/forums/showt...407&highlight=

My reason for wanting to use the ignition wires is because on the 09+ R1 and maybe the R6 you can not go into DANG mode (self diagnostic mode) with the current setup.

If someone could please PM me with a set of plans or instructions it would be greatly appreciated. Thank You...

PS If my integrity is questionable because I am a new member with few post, please visit r1-forum.com my screen name is the same and I am a very active member with positive feed back.

here is what I have now: in case the link does not work:

With or With out the Key ignition NO SWITCH











 
1 - 2 of 2 Posts
Top