Yamaha R6 Forum: YZF-R6 Forums banner
1 - 1 of 1 Posts

·
I ride my wife and her R6
Joined
·
101 Posts
They wire wasn't what was causing your plug to burn up. Corrosion is what causes that. If you want to prevent this in the future, check all of the plugs on your harness, clean them and put dielectric grease in all of the connections to prevent moisture buildup and further corrosion. If you guys do a little searching you will find the answers to these problems. Electrical problems more often than not stem from corrosion.

Look at the link below, I just went through this in another thread this morning. Good luck.

http://www.r6-forum.com/forums/showthread.php?t=327081
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top