help on stuck shogun bar slider

1364 Views 7 Replies 4 Participants Last post by redwood650, May 24, 2008

youngn1m

Discussion Starter · May 13, 2008

so i tried to install the shogun bar sliders and i must have tightened them too tight or something and the actual bar slider piece broke off while the threaded piece is now stuck in my throttle.

i have tried to muscle it out with no luck - kept threading the stick piece....:bash

is there any way to get this thing out? ive tried wd-40 but that doesnt seem to work either.....

any help would be greatly appreciated

Save

1 - 3 of 8 Posts

youngn1m

Discussion Starter · #3 · May 14, 2008

thanks for the reply....

its the metal adaptor that is stuck in the bar end.....i think it did get cross threaded....

is there any way to get this thing out? maybe i should take it to a shop and have them take a look at it.....

Save

youngn1m

Discussion Starter · #7 · May 24, 2008

thanks for all the replies....really appreciate it....

how hard is it to replace the clip on? is it pretty labor intensive?

Save

1 - 3 of 8 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month