Yamaha R6 Forum: YZF-R6 Forums banner

1 - 3 of 3 Posts

·
pin it to win it
Joined
·
8,080 Posts
Discussion Starter · #1 ·
Ok I got a new main wiring harness cause I ****ed up my last one. I installed the new harness and flipped my keyless switch. My gauge came on and showed no check engine light, and the fuel pump primed, good. Thumbed the starter and turned it over and over and over nothing. Flipped the switch back off added some gas cause it was really low. Went to flip the switch back on and nothing happened. Sometimes my switch had to be pressed really hard to get it to work. Tried that a few times and didn't work so I thought if I just cross the wires it'd work, but it didn't. If I cross these 2 wires it should come on correct? Well I crossed them and not shit happened.

So now I'm clueless as what to check or do. Any help would be so appreciated my bikes been down for months. Thanks
 

Attachments

·
pin it to win it
Joined
·
8,080 Posts
Discussion Starter · #2 ·
Checked the fuses and they are good.
 

Attachments

·
pin it to win it
Joined
·
8,080 Posts
Discussion Starter · #3 ·
Thanks for the help guys lol
I found the issue. The main 50amp fuse.
Any idea how I could have managed that? Not grounding the switch perhaps?
 

Attachments

1 - 3 of 3 Posts
Top